Table of Contents
Advertisement
Projecting
Check the connections of the peripheral devices and connection of the power cord (
power (
page 26) to start the projector. Select the image and adjust the state of the image.
Æ
Selecting the input signal
Select an input signal.
Press <INPUT> button on the control panel or the <INPUT>,
<HDMI>, <COMPUTER>, <VIDEO> on the remote control.
The image of the signal being input in the selected terminal is projected.
z
Press <INPUT> button to display the [Source] menu. Press
z
▲▼ to select the desired input and press ► to enter.
How to adjust the state of the image
1 )
Adjust the projection angle.
Place the projector parallel to the screen, and then install it on a flat surface so that the screen becomes
z
rectangle.
If the image is tilted lower than the screen, extend the adjustable feet to make a rectangle screen.
z
For details, see "Adjusting the Projector's Height" (
z
2 )
Adjust the zoom and the focus.
Turn the zoom lever and the focus ring to adjust the image.
Note
It is recommended that the images are projected continuously for at least 30 minutes before the focus is adjusted.
z
If keystone distortion occurs, see [V Keystone] in the [Position] menu (
z
page 21).
Æ
Zoom Lever
Focus Ring
Æ
page 36).
Projecting
page 24) and switch on the
Æ
ENGLISH -
27
Advertisement
Table of Contents
