Related Manuals for Panasonic PT-LX270
Summary of Contents for Panasonic PT-LX270
- Page 1 PT-LX270 P ro d u c t N u m b e r : ™ Projector P ro d u c t N a m e : As of June 2013. Specifications and appearance are subject to change without notice.
- Page 2 PT-LX270 ™ Projector Specifications Main unit Power supply 100−240 V AC, 50/60 Hz Power consumption 218 W (0.5 W when set to , 6.0 W when STANDBY MODE set to STANDBY MODE NORMAL. DLP™ chip Panel size 14.0 mm (0.55 inches) diagonal (4:3 aspect ratio) Display method DLP™...
- Page 3 PT-LX270 ™ Projector Dimensions (W × H × D) 286 mm × 100.6 mm* × 192 mm (11-1/4 x 3-31/32* x 7-9/16 inches) Weight Approx. 2.3 kg (5.1 lbs) Operation noise* 34 dB ( ), 29 dB ( LAMP POWER...
- Page 4 PT-LX270 ™ Projector Dimensions 286 (11-1/4) unit : mm (inch) NOTE: This illustration is not drawn to scale. Terminals AUDIO IN VIDEO SERIAL COMPUTER IN MONITOR OUT VARIABLE AUDIO OUT HDMI input Computer input Video input Serial input Monitor output...
-
Page 5: Standard Setting-Up Position
PT-LX270 ™ Projector Standard setting-up position unit : mm (inch) ø38 (1-1/2) Upper edge of projected image (4-19/32) (2-15/16) Screen Lower edge of projected image (8-29/32) (7-7/8) NOTE: Illustrations show the projector Screen installed using optional ceiling mount bracket ET-PKV100H and attachment ET-PKL300B. - Page 6 PT-LX270 ™ Projector Projection distance for 4:3 aspect ratio screen unit: meters (feet) Projection size Projection distance [L] Height from the edge of screen [diagonal] Min [wide] Max [telephoto] to center of lens [ H ] 0.76 m 30˝ (3.9) (4.3)
- Page 7 PT-LX270 ™ Projector List of compatible signals The signals that can be input to this projector are shown in the table below. Display mode Display Scanning frequency Dot clock Format resolution frequency (dots) (kHz) (Hz) (MHz) NTSC/NTSC4.43/PAL-M/PAL60 59.9 – VIDEO/S-VIDEO 720 ×...
- Page 8 PT-LX270 ™ Projector Serial connector The serial connector complies with RS-232C. To control the projector from a personal computer, com- mands must be input through communication software, based on the format and satisfying the commu- nication conditions shown below. Pin assignments and signal names Pin No.
- Page 9 PT-LX270 ™ Projector Cable specifications Projector PC (DTE) Control commands Command : Parameter Function Callback Standby power on PO N POWER (STANDBY) Standby power off PO F IIS:HD1 HDMI II S: HD 1 INPUT SELECT Computer IIS:RG II S: RG...
- Page 10 PT-LX270 ™ Projector Notes on projector placement and operation The projector uses a high-wattage lamp that becomes very hot during operation. Please observe the following precautions. Never place objects on top of the projector while it is operating. Make sure there is the unobstructed space as shown below or more around the projector’s exhaust openings.