Hitachi HTS542525K9SA00 Specifications page 210

Feature Current
Feature Previous CCTL (7:0)
Sector Count Current
Sector Count Previous
Sector Number Current
Sector Number Previous
Cylinder Low Current
Cylinder Low Previous
Cylinder High Current
Cylinder High Previous
Input Parameters From The Device
Sector Number (HOB=0)
Sector Number (HOB=1)
Cylinder Low (HOB=0)
Cylinder Low (HOB=1)
Cylinder High (HOB=0)
Cylinder High (HOB=1)
CCTO (Error, bit 0)
The time allowed for the current command's completion is
calculated as follows:
= (content of the Feature register
vious) * (Identify Device words (99:98)) useconds
If the value is zero, the device shall use the Default
CCTL supplied with a previous Configure Stream command
for this Stream ID. If the Default CCTL
previous Configure Stream command was defined for this
Stream ID, the drive will ignore the CCTL.
measured from the write of the command register to the
final INTRQ for command completion.
The number of continuous sectors to be transferred low
order, bits (7:0)
The number of continuous sectors to be transferred high
order, bits (15:8).
Count register, then 65,536 sectors will be transferred.
LBA (7:0).
LBA (31:24).
LBA (15:8).
LBA (39:32).
LBA (23:16).
LBA (47:40).
LBA (7:0) of the address of the first unrecoverable
error.
LBA (31:24) of the address of the first unrecoverable
error.
LBA (15:8) of the address of the first unrecoverable
error.
LBA (39:32) of the address of the first unrecoverable
error.
LBA (23:16) of the address of the first unrecoverable
error.
LBA (47:40) of the address of the first unrecoverable
error.
CCTO bit shall be set to one if a Command Completion
Time Limit Out error has occurred.
Deskstar 7K160 Hard Disk Drive Specification
196
Command Completion Time Limit
If zero is specified in the Sector
Pre-
is zero, or no
The time is