Hitachi C4K60 - Travelstar Slim - Hard Drive Specifications page 70

Word
89 Time required for security erase unit completion
Word 89 specifies the time required for the SECURITY ERASE UNIT
command to completion. If word 90 is 0000h, the time is not specified.
SECURITY ERASE UNIT completion time = value x 2[minutes]
90 Time required for enhanced security erase unit completion
Word 90 specifies the time required for the ENHANCED SECURITY ERASE
UNIT command to completion. ENHANCED SECURITY ERASE UNIT
completion time = value x 2[minutes]. If Word 90 is 0000h, the time is not
specified.
91 Current advanced power management level value
Word 91 contains the current Advanced Power Management level settings.
92 Master password revision code
Word 92 contains the value of the Master password revision code set when the
Master Password was last changed.
93 Hardware reset result
bit 15
bit 14
bit 13
bit 12 - 8
bit 7 - 0
K6610170
Rev.2
Dec 22, 2004
Table 7.8 IDENTIFY DEVICE information(Continued)
Description
0 (fixed)
1 (fixed)
1 = Device detected CBLID- above V
0 = Device detected CBLID- below V
Device 1 hardware reset result. Device 1 clears these bits to
zero. Device 1 sets these bits as follows:
bit 12 0 = Reserved
bit 11 1 = Device 1 asserted PDIAG-
bit 10 - 9 These bits indicate how Device 1 determined the
device number:
00, 11 = Reserved
01 = A jumper was used
10 = the CSEL signal was used
bit 8 1 (Fixed)
Device 0 hardware reset result. Device 1 clears these bits to
zero. Device 0 sets these bits as follows:
bit 7 0 = Reserved
bit 6 1 = Device 0 responds when Device 1 is selected
bit 5 1 = Device 0 detected the assertion of DASP-
bit 4 1 = Device 0 detected the assertion of PDIAG0
bit 3 1 = Device 0 passed diagnostic
bit 2 - 1 These bits indicate how Device 0 determined the
device number:
00, 11 = Reserved
01 = A jumper was used
10 = the CSEL signal was used
bit 0 1 (Fixed)
iH
iL
- 70 -
Value
(HEX.)
00XXh
00XXh
40XXh
XXXXh
XXXXh