Advertisement
Preparing for l~ll~"on
cooktop is
designed
in a cabinet itk same width.
The exhaust vent beneath the cooktop must be
located be~een wd studs or floor joists so that
At least 6" must be allowed be~een side edges
of cooktop and adjacent wds.
Avoid placing abinets above the cooktop
if possible, in order to reduce the h~ds
caused by reaching overheated surface units.
can be reduced by ins~g a range hood that
projects hotiontiy a hum of 5 inches
beyond the bottom of the mbinets.
surface md the bottom of any unprotected ~binet
clearance
less than 30", mbinet bottom must be proteded
with flame retardant mi~board at least 1/4"
thick, covered with 28 gauge sheet steel or
0.020" thick copper, Clearance between cooktop
and protected ~binetry must NE~R BE ~
oven or cooking apptiance over the cooktop sh~
conform to the initiation instructions packed
with that apptiance.
minimum must be kept from the side
A
15"
edge of cooktop to the bottom of any =binet
not directiy above cooktop. H
15", adjacent cabinets should beat least
than
6" from side edge of cooktop.
34
to look best when centered
unit,
clearance is less
Step 2
Preparing ho ~ tibinti
of cabinets. Howeveq some cabinets may require
modifications.
some cabinets, the sides may need to be scooped
or cut down 2" as shown, and the corner braces
removed in order to accommodate the unit.
a peninsula or island type cabinet, the sides
may need to be scooped or cut down, and the
corner braces removed in order to accommodate
the unit.
3
Step
Rough Propation of Jundon Mx
area shown in diagram. Junction box must be at
least 10%" below top of cabinet.
Run conductors from residence wiring to
junction box according to lod electrid codes.
g" ~
unit
5"
for European
Advertisement
