Operation; Cleaning And Storage - Honeywell HT-900 Owner's Manual

• Remove the packaging
material from the Fan
Control Box.
• Remove the holding
screw from the rear of
the Fan Control Box
(Fig. 1).
• Push the Fan Control
Box Extension through
the opening in the right
leg of the fan base
(Fig. 1).
• Set your fan on a level,
dry surface.
• Plug the power cord
into a polarized 120 volt
AC wall outlet.
• Select the desired
• Turn the Control to OFF
and UNPLUG THE FAN
BEFORE CLEANING.
• Use only a soft, damp
cloth to clean the fan.
• DO NOT immerse the
fan in water and never
allow water to drip into
the Motor Housing.
• DO NOT use gasoline,
ASSEMBLY INSTRUCTIONS
• Replace the holding
screw and firmly tighten
the Fan Control Box onto
the base (Fig. 1).
NOTE: When installing
the Control Box, make
sure the electrical wires
are located on the out-
side of the base (Fig. 1).
speed for your needs. For
maximum air circulation,
you may point the fan
towards the ceiling.
DW-518 Fig. 2
Using this method during
the summer and winter
will move the warm air
from the ceiling, dispers-

CLEANING AND STORAGE

paint thinner or other
chemicals to clean the
fan.
• To clean the Fan Blade,
use 2 screwdrivers to
disengage the 8 hooks
holding the Front Grille to
the Rear Grille (Fig. 2).
• Remove the Front Grille.
• Wipe the Blade and
Grilles.
Fig. 1

OPERATION

ing it and giving you a
more uniform room tem-
perature.
• Adjust the pivoting head
to direct the powerful
breeze where desired.
• Reassemble the fan by
snapping the Front Grille
into place.
Fig. 2
FAN
CONTROL
BOX
HOLDING
SCREW