Status LEDs and Buttons
Status LEDs and Buttons
This section describes the location and meaning of LEDs and buttons and includes the following topics
•
•
•
Front Panel LEDs
Figure 3-1
Figure 3-1
1
1
2
3
4
5
Table 3-1
Front Panel LEDs, Definitions of States
LED Name
Hard drive fault
Hard drive activity
Network link activity
Cisco UCS C240 Server Installation and Service Guide
3-2
Front Panel LEDs, page 3-2
Rear Panel LEDs and Buttons, page 3-4
Internal Diagnostic LEDs, page 3-6
shows the front panel LEDs.
Front Panel LEDs
2
Hard drive fault LED
Hard drive activity LED
Network link activity LED
Power supply status LED
Temperature status LED
State
•
Off—The hard drive is operating properly.
Amber—This hard drive has failed.
•
Amber, blinking—The device is rebuilding.
•
Off—There is no hard drive in the hard drive sled (no access, no fault).
•
Green—The hard drive is ready.
•
Green, blinking—The hard drive is reading or writing data.
•
•
Off—The Ethernet link is idle.
•
Green—One or more Ethernet LOM ports are link-active, but there is no activity.
•
Green, blinking—One or more Ethernet LOM ports are link-active, with activity.
Table 3-1
defines the LED states.
6
Fan status LED
7
System status LED
8
Identification button/LED
9
Power button/power status LED
–
Chapter 3
Maintaining the Server
3
5
7
9
OL-25761-01
4
6
8