Cisco UCS C24 Installation And Service Manual page 68

Installing or Replacing Server Components
Slide the server out the front of the rack far enough so that you can remove the top cover. You might
b.
have to detach cables from the rear panel to provide clearance.
Caution If you cannot safely view and access the component, remove the server from the rack.
c. Remove the top cover as described in
page
Identify the faulty DIMM by observing the DIMM slot fault LEDs on the motherboard (see
d.
Figure
Open the ejector levers at both ends of the DIMM slot, then lift the DIMM out of the slot.
e.
Install a new DIMM:
Step 2
Note
Align the new DIMM with the empty slot on the motherboard. Use the alignment key in the DIMM
a.
slot to correctly orient the DIMM.
Push down evenly on the top corners of the DIMM until it is fully seated and the ejector levers on
b.
both ends lock into place.
Replace the top cover.
c.
Replace the server in the rack, replace cables, and then power on the server by pressing the Power
d.
button.
Cisco UCS C240 Server Installation and Service Guide
3-28
3-8.
3-3).
Before installing DIMMs, refer to the population guidelines. See
Guidelines and Population Rules, page
"Removing and Replacing the Server Top Cover" section on
3-24.
Chapter 3 Maintaining the Server
Memory Performance
OL-25761-01