Point-To-Point Protocol Over Ethernet (Pppoe) - EnGenius ENS202EXT User Manual

B N S P - -P P E (PPP E)
ASIC ETWORK ETTINGS OINT TO OINT ROTOCOL OVER THERNET O

Point-to-Point Protocol over Ethernet (PPPoE)

Point-to-Point Protocol over Ethernet (PPPoE) is
used mainly by ISPs that provide DSL modems to
connect to the Internet.
MTU Enter the maximum transmission unit (MTU).
The MTU specifies the largest packet size
permitted for an internet transmission (PPPoE
default: 1492). The MTU size can be set between
512 and 1492.
Login Enter the username assigned by an ISP.
Password Enter the password assigned by an
ISP.
Service Name Enter the service name of an ISP
(optional).
Connect on Demand Select the radio button to
specify the maximum idle time. Internet connection
will disconnect when it reach the maximum idle
time, but it will automatically connect when user tries to access the network.
Keep Alive Select whether to keep the Internet connection always on, or enter a redial period once the internet lose connection.
Get Automatically From ISP Click the radio button to obtain the DNS automatically from the DHCP server.
Use These DNS Servers Click the radio button to set up the Primary DNS and Secondary DNS servers manually.
Discard Ping on WAN Check to Enable to recognize pings on the ENS202EXT WAN interface or Disable to block pings on the
ENS202EXT WAN interface. Note: Pinging IP addresses is a common method used by hackers to test whether the IP address is
valid. Blocking pings provides some extra security from hackers.
Click Accept to save the settings or Cancel to discard changes.
4-14