Before You Start; Check The Package Contents - Uniden UIP1868P Quick Start Manual

Quick Start Guide
This Quick Start Guide assumes you have the following
items available:

A broadband modem and an active broadband Internet service.
 A computer with an Ethernet port.
 A CAT-5 Ethernet cable (RJ-45).

A DHCP client running your computer (e.g., your ISP automatically
assigns an IP address to your computer). For installations with a fixed
IP address or special configurations, please see the Administrator's
Guide at www.uniden.com/voip.

Before You Start:

Consult your VoIP service provider for configuration information.

Check the package contents

1
Make sure the package contains the following items:

UIP1868 main base

Cordless handset and charger

2 AC power adapters

Belt clip

Connect the UIP1868
2
Use the coil cord to connect the corded handset to the main base.

Connect the UIP1868 to your network as follows:

1 Use the included Ethernet
cable to connect your
broadband modem to the
RJ-45 port labeled WAN.
If you subscribe to a second line, use a
telephone cord to connect a phone or
fax to the RJ-11 port labeled VoIP2.
CAUTION:
Do not connect the UIP1868 to a regular telephone wall jack.
All the LEDs will flash, and the PWR LED remains on. If your service
provider recognized and registered your UIP1868, the CA (call agent)
LED will also remain on.
Rechargeable battery pack

One coiled handset cord

One CAT-5 Ethernet cable (RJ-45)

Printed materials

2
Use another Ethernet cable
to connect your PC or router
to the RJ-45 port labeled LAN.
3
Use the AC adapter to
connect the port labeled
POWER to a 120 Vac
continuous power outlet.
Configure for your service provider
3
Open an Internet Explorer web browser window.

In the address bar, enter the IP address 192.168.15.1.

At the login prompt, enter the user ID admin and the

password UnidEn79!.
Install Your Cordless Handset and Charger
Install the Handset Battery Pack
1
NOTE: Use ONLY the Uniden rechargeable battery pack
supplied with your new phone!
1
Remove the cover.
3
Replace the cover.
Charge the Cordless Handset
2
Connect the AC adapter cord to the

DC IN 9V jack on charger, then plug
into a 120V AC power outlet.
Place the handset in the charger.

Make sure that charge LED illuminates.
Charge the handset 15-20 hours.
NOTE: Fully charge the battery pack before using the handset.
Make & Receive Calls with the Cordless Handset
3
To make a call: To receive a call:
 
Pick up the handset
 
Press
and press
Listen for dial tone.

Dial the number.

NOTE: 911 service may require separate registration or activation from your service
provider; your service provider may also charge a separate subscription fee for
911 service. Read all instructions from your service provider carefully and be sure
you understand the procedures and costs involved in obtaining 911 service.
Voice quality and reliability may vary depending on your VoIP service provider's
network and your broadband ISP connectivity.
2
Connect the
battery pack
with the correct
polarity.
To end a call:

Press

return the handset
to the charger.
or