Table of Contents
Advertisement
About the Liquid Crystal Display
The unit is equipped with a two-line liquid crystal display (LCD) on the operation
panel for displaying various messages and settings during operation. This LCD can
display up to 20 characters on each line. When the unit is idle, the LCD shows the
date, time, and the stand-by memory available.
Example:
Located to the upper right of the operation panel, the LCD contrast dial controls the
contrast of the display.Turning the dial to the right darkens the LCD. Turning the dial
to the left lightens the LCD.
The left and right arrow (
useful for scrolling through the various function lists and settings. Once you have
pressed the FUNCTION key, you can scroll through the eight functions as desired.
(See the Function Table at the end of the Quick Reference Guide for an at-a-glance
view of all the unit's functions and settings.) Pressing the ENTER key chooses the
displayed function. For many of the function lists, you can then use the arrow keys
again to scroll through the settings.
Adjust the volume of both key beeps and alarm beeps (emitted at the end of transmission
and reception) using the procedure below.
Factory setting: 3 (MEDIUM)
Step
Press these keys
1
FUNCTION
2
3
4
ENTER
5
STOP
2-2
02 INITAL. b(SUK) A5.p65
Using the Arrow Keys
) keys on the operation panel of the unit are very
Adjusting the Beep Volume
GHI
MNO
or
STOP
INITIAL SETTINGS
2
Comments
"OPTION SETTING" will appear
in the display.
"BEEP VOLUME" will appear in
the display.
Press the
or
key to lower
or raise the volume to the
desired level.
"STORED" will appear in the
display.
Press the STOP key twice to
exit.
11/10/99, 13:40
Advertisement
Table of Contents
