Belt Clip; Nstalling The Elt Lip; Nstalling The; Ap Over The - Kenwood NEXEDGE NX-410 Instruction Manual

I

NSTALLING THE

Attach the belt clip using the
supplied 3 x 8 mm screws.
Note: If the belt clip is not
installed, its mounting location
may get hot during continuous
transmission or when left sitting in
a hot environment.
Do not use glue which is designed to prevent screw loosening when
installing the belt clip. Acrylic ester, which is contained in these
glues, may crack the transceiver's back panel.
I
NSTALLING THE
Insert the cap into place over the
universal connector and secure
it in place using the attached
screw.
I
NSTALLING THE
1 Insert the guide of the
speaker/ microphone or
headset connector into place
over the universal connector.
2 Secure the connector in place
using the attached screw.
Note: When not using an optional
speaker/ microphone or headset,
install the cap over the universal
connector.
B C
ELT LIP
C

AP OVER THE

(O ) S
PTIONAL PEAKER
U C
NIVERSAL ONNECTOR
/ M
ICROPHONE OR

Belt clip

3 x 8 mm screws
Universal
connector cap
H
EADSET
Optional
speaker/ microphone
3