Installing The Belt Clip; Installing The Cap Over The Speaker/ Microphone Jacks - Kenwood ProTalk Digital TK-3401D Quick Reference Manual

INSTALLING THE BELT CLIP

Do not use glue which is designed to prevent screw loosening when
installing the belt clip, as it may cause damage to the transceiver. Acrylic
ester, which is contained in these glues, may crack the transceiver's back
panel.
INSTALLING THE CAP OVER THE SPEAKER/
MICROPHONE JACKS
Install the cap over the speaker/ microphone jacks when not
using an optional speaker/ microphone.
Note:
◆ To keep the transceiver water resistant, you must cover the
speaker/ microphone jacks with the supplied cap.
1 Place the cap over the jacks so that the locking
2 While holding the cap in place, push it towards
4
If necessary, attach the belt clip using
the two supplied M3 x 8 mm screws.
Note:
◆ If the belt clip is not installed, its
mounting location may get hot during
continuous transmission or when left
Belt clip
sitting in a hot environment.
tabs insert into the transceiver grooves.
the bottom of the transceiver until the tabs on
the cap click into place.
• To remove the cap, hold the top of the cap
in place with your fi nger while inserting a 2
mm or smaller fl at blade screwdriver under
the bottom of the cap. Slowly slide the
screwdriver in until its tip touches the tab
inside the cap, then gently pry the cap up
(handle of screwdriver moving away from
the transceiver) to remove the cap.