Battery Life; Installing The Belt Clip; Installing The Hand Strap - Kenwood TH-D75A User Manual

¡ Charging through the DC IN jack and USB connector when the
transceiver is turned ON can be prevented. Access Menu No. 923
(page 25).
For charging the battery pack with the USB
cable (USB Type-C
TM
1 Plug the USB cable into an AC adapter, etc.
2 Attach the battery pack to the transceiver, and plug the
USB plug into the USB connector while the transceiver
power is OFF.
USB connector
Note ：
¡ To avoid a failure or abnormal heat generation, be sure to use a
USB converter AC adapter (sold separately) with a 5 V output
voltage and a current of 2 A or higher.
¡ Do not use a USB cable exceeding 3 m (9.8 feet).
¡ Charging from the USB cable is not guaranteed to work with all
USB cables or AC adapters.
¡ Charging time with the USB connector may be longer than with the
supplied charger.
¡ If the DC IN cable and USB cable are both connected, you cannot
charge from the USB cable. The DC IN route has priority.
¡ Charging through the DC IN jack and USB connector when the
transceiver is turned ON can be prevented. Access Menu No. 923
(page 25).
For charging the battery pack with the optional
rapid battery charger
Note ：
¡ Insert the battery pack only in the rapid battery charger to charge a
battery pack that has been in storage for a long time.
¡ If the battery pack is completely depleted while using the
transceiver, remove the battery pack from the transceiver and
insert the battery pack in the rapid battery charger.
¡ When the battery is installed on the transceiver and you are using
an optional rapid battery charger, do not charge the battery from
the DC IN jack/ USB connector. Charging the battery from the DC
IN jack/ USB connector may result in overcharging the battery
which can result in the shortening of the battery life cycle.
Charger Error
• While charging, if a problem is detected in the battery,
"Charge Error !!" appears on the display.
• The following condition create charging error:
Overvoltage in the battery is detected.
• When a charge error occurs, no key other than [ ] will
function.
)
USB Type-C
TM

BATTERY LIFE

Before you operate the transceiver outside using a battery
pack, it is important to know how long the battery pack will
last.
If the battery saver setting is 1.0 sec and the GPS setting is
Off in the single band operation, the operating times listed in
the table below are the referential values under the following
cyclic conditions: TX: 6 seconds, RX: 6 seconds, Stand-by: 48
seconds
We recommend you carry extra battery packs with you, in
case the battery pack becomes depleted.
Battery Type Output Power
KNB-75LA
Li-ion battery pack

INSTALLING THE BELT CLIP

If desired, you can install the supplied belt clip to the
transceiver.
Attach the belt clip firmly using the two supplied M3 x 6 mm
binding screws.
Screws
Note ：
¡ Be careful not to pinch your fingers into the belt clip
CAUTION
• Do not use glue which is designed to prevent screw
loosening when installing the belt clip, as it may cause
damage to the transceiver. Acrylic ester, which is
contained in these glues, may crack the transceiver's
back panel.

INSTALLING THE HAND STRAP

If desired, you can install the commercially available strap with
sufficient strength using the holes of the transceiver.
Note ：
¡ If the strap is thick and does not pass through the holes, install the
strap using the holes of the supplied belt clip.
PREPARATION
Operating Time/
Hours (Approx.)
H 6
M 8
L 12
EL 15
Belt clip
.
7