Installation Procedure During Parts Replacement; Top Packing (G53-1638-04) Installation Procedure; Volume Torque-Up Packing (G53-1628-04) - Kenwood TK-5210 Service Manual

■ Top Packing (G53-1638-04) Installation Procedure

1. Ensure that the hardware fixture is first secured to the
chassis.
2. Hook the packing (coated with silicon oil) in the upper left
1
groove of the chassis , then fit the packing into the right
2
groove of the chassis.
Hardware fixture
2
Notes:
• Verify that the chassis grooves and packing are free from
dirt and dust.
• To remove the packing from the chassis groove, use a
resin adjustment bar or other such device. If the packing
is pried with a sharp metallic tool, such as tweezers, the
packing may become damaged.
3. Verify that the packing fits snuggly into the groove of the
chassis.

■ Volume Torque-up Packing (G53-1628-04)

Installation Procedure
Insert the packing using a pair of tweezers so that the
hollow of the packing fits the convex of the panel
Volume torque-up packing
■ Screw sequence for mounting the battery
terminal block to the chassis.
Attach the battery terminal block to the chassis as
described in the following procedure.
1. Loosely fix the hexagon screws of the GND terminal to
the chassis (enough so that the hexagon screws do not
move).
GND terminal
DISASSEMBLY FOR REPAIR
1
Top packing
1
.
1
2. Tighten the two screws from the TX-RX PCB side.
3. Firmly tighten the hexagon screws of the GND terminal.
Installation Procedure during Parts
Replacement
■ Attaching the Sheet (G10-1338-04, J99-0383-14)
to the Front Case Speaker and Installation of
the Packing (G53-1633-04)
1. Attach a new fiber sheet
convex fits the hollow of the front case
2. Attach a new pressure sensitive adhesive sheet
0383-14) so that its convex fits the hollow of the front
4
case .
3. Remove the separation sheet from the pressure sensitive
adhesive sheet with a pair of tweezers
6
4. Fit the packing (G53-1633-04) into the front case
speaker.
Note:
Fit the packing into the hollow of the case so that the two
low-height places in the convex of the packing are posi-
7
tioned on the lower side
6
7
3
1
2
5. Verify that the packing does not ride on the rib of the case.
TK-5210
Two screws
1
(G10-1338-04) so that its
2
.
3
(J99-
5
.
.
4 5
11