Tx-Rx Pcb Installation Procedure; Lcd Assy Installation Procedure; Main Packing (G53-1637-04) Installation Procedure - Kenwood TK-5210 Service Manual

TK-5210
7. Insert the VOL/CH FPC
into the connectors (CN902, CN903) of the TOP PCB.
8. Fix the TOP PCB with a screw
9. Fix the TOP PCB with a screw

■ TX-RX PCB Installation Procedure

1. Insert the coaxial cable of the antenna receptacle into the
coaxial connector (CN101) of the TX-RX PCB
coaxial cable of the ANT PCB into the coaxial connector
(CN102) of the TX-RX PCB
2. Grasp both sides of the lower part of the TX-RX PCB, tilt
the TX-RX PCB and install the chassis so that the PTT FPC
3
, CONTROL-TOP FPC
5 6
are not caught
3. Fix the TX-RX PCB with the 14 screws.
6
Grasp both sides of the lower part
of the TX-RX PCB

■ LCD ASSY Installation Procedure

models only)
1. Remove the two adhesive sheets attached to the
CONTROL PCB, and attach the new adhesive sheets to
the location as shown in the following figure.
Adhesive sheet
(J99-0394-04)
2. Fold the LCD ASSY FPC to the back of the holder
that the FPC is between the two tabs on the right side of
2
the holder .
LCD ASSY FPC
1
10
DISASSEMBLY FOR REPAIR
8
and the CONTROL-TOP FPC
0
.
!
.
10
11
CN902
8
9
CN903
1
2
.
4
and universal connector FPC
.
CN102
2
3
5
4
(K2 and K3
Adhesive sheet
(J99-0393-04)
CONTROL PCB
tab
tab
2
9
3. Fit the two tabs on the right side of the holder
two tabs on the left side of the holder
CONTROL PCB.
Note:
Take care that the FPC is not caught when fitting the two
tabs on the right side of the holder.
and the
4. Insert the FPC into the CONTROL PCB connector (CN751)
5
.
1

■ Main Packing (G53-1637-04) Installation Procedure

CN101
1. Hook the packing (coated with silicon oil) in the upper
groove of the chassis
lower groove of the chassis
Note:
Ensure that the chassis grooves and packing are free from
dirt and dust.
2. Fit the packing into the grooves on both sides of the
3
chassis . (Fit the packing into the groove in the chassis
by tracing it lightly with your fingers.)
2
1
so
Note:
To remove the packing from the chassis groove, use a
resin adjustment bar or other such device. If the packing
is pried with a sharp metallic tool, such as tweezers, the
packing may become damaged.
3. Verify that the packing fits snuggly into the groove of the
chassis.
tab
3
4
3
4
CONTROL PCB
CN751
5
1
, then fit the packing into the
2
.
Main packing
3
3
3
and the
4
into the
1