Maintenance Schedule - Schwinn IC Elite Indoor Cycling Bike Owner's Manual

Maintenance Schedule

Daily maintenance or at the end
of each workout
Weekly maintenance
Monthly maintenance
In order to ensure proper function and safety, use only genuine Schwinn
Maintenance
• Release the brake resistance so that the brake pads do not contact the
flywheel.
• Clean the bike with Schwinn
• Remove the handlebars from the head tube to allow the handlebar tube and
sleeve to dry.
IMPORTANT! To avoid damaging the finish on your Schwinn
petroleum-based solvent when cleaning.
• Inspect the Schwinn
®
special attention to the brake assembly, seat and handlebar pop-pins. This will
prolong the service life of the product.
• Lubricate drive chain with bicycle lubricant containing PTFE (Teflon
lubricant through the hole in the top of the chainguard.
• Lubricate seat post and handlebars with Schwinn
ensure smooth operation.
• Make sure handlebar and seat pop-pins are fully tightened and operating
smoothly.
• Inspect toe clips and toe straps for any signs of wear or rough movement.
Replace the components if any signs of wear are noticed.
• Check that both pedals are secured and properly attached to the crank arms.
Inspect pedals by rotating the pedals by hand, if any rough movement or noise
is observed replace the pedals immediately.
NOTE: Only trained personnel should change the pedals. Unqualified people
performing this procedure can cause threads to cross. Crossed threads do
not qualify for warranty replacement.
• Check the chain for proper adjustment. Move the crank arms back and forth.
If there is more than 1/4" (0.64 cm) movement in the crank before the flywheel
turns, tighten the Chain. (See Chain Adjustment instructions.)
NOTE: Make sure you adjust both sides equally so that the flywheel remains in
alignment with the frame.
• Check the crank bolts with a torque wrench. The torque should not exceed
360 lbf/in (40.67 Nm) for IC Pro
Evolution models.
®
12
Owner's Manual
equipment polish and a clean damp cloth.
®
Indoor Cycling bike for loose parts, nuts, bolts, etc. Pay
and IC Elite and 420 lbf/in (47.45 Nm) for the
™ ™
IC replacement parts supplied by Nautilus.
®
IC Bike, never use a
®
). Put the
®
Fit Tech silicon lubricant to
® ®