Maintenance And Troubleshooting - Reebok 610 Bike Manual

MAINTENANCE AND TROUBLESHOOTING

Inspect and tighten all parts of the exercise bike regu-
larly. Replace any worn parts immediately.
To clean the exercise bike, use a damp cloth and a
small amount of mild soap. IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
CONSOLE TROUBLESHOOTING
If the console does not turn on, make sure that the
power adapter is fully plugged in. If lines appear in the
console display, see HOW TO CHANGE CONSOLE
SETTINGS on page 25 and adjust the contrast level
of the display.
If the handgrip heart rate monitor does not function
properly, see step 5 on page 20.
If the console does not display your heart rate
when you use the chest heart rate monitor, see
TROUBLESHOOTING on page 16.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the reed
switch, first unplug
the power adapter.
Using a flat screw-
driver, release the
tabs at the front and
along the sides of
the Top Shield (44).
Then, slide the Top
Shield upward.
44
27
Locate the Reed Switch (46). Rotate the Pulley (29)
until a Pulley Magnet (30) is aligned with the Reed
Switch. Loosen, but do not remove, the indicated M4
x 16mm Screw (77). Slide the Reed Switch slightly
toward or away from the Pulley Magnet.
29
Then, retighten the M4 x 16mm Screw (77). Plug in the
power adapter and turn the Pulley (29) for a moment.
Repeat these actions until the console displays correct
feedback.
When the reed switch is correctly adjusted, reattach
the top shield and then plug in the power adapter.
77
46
30