Maintenance And Troubleshooting - Reebok Trainer Rx 3.5 Bike Manual

MAINTENANCE AND TROUBLESHOOTING

Inspect and tighten all parts of the exercise bike regu-
larly. Replace any worn parts immediately.
To clean the exercise bike, use a damp cloth and a
small amount of mild soap. IMPORTANT: To avoid
damaging the console, keep liquids away from
the console and keep the console out of direct
sunlight.
CONSOLE TROUBLESHOOTING
Most console problems are the result of low batteries.
See assembly step 7 on page 9 for battery replace-
ment instructions.
If the handgrip heart rate monitor does not function
properly, see step 5 on page 16.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
If you are using the optional power adapter, unplug it.
Using a flat screwdriver, release the tabs on the Shield
Cover (5) and pull the Shield Cover upward.
Locate the Reed Switch (46). Turn the Pulley (58) until
a Magnet (52) is aligned with the Reed Switch. Next,
loosen, but do not remove, the indicated M4 x 13mm
Flange Screw (92). Slide the Reed Switch slightly
closer to or away from the Magnet, and then retighten
the Screw. Turn the Pulley for a moment.
92
52
46
5
58
Repeat these actions until the console displays correct
feedback. When the reed switch is correctly adjusted,
reattach the shield cover.
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, even when
the resistance is adjusted to the highest setting, the
drive belt may need to be adjusted.
If you are using the optional power adapter, unplug it.
Next, using an adjustable wrench, turn the right pedal
counterclockwise and remove it.
Using a flat screwdriver, release the tabs on the Shield
Cover (5) and slide the Shield Cover upward.
5
22
Remove all of the screws from the Left Front Shield
(22) and the Right Front Shield (not shown); there are
three sizes of screws——note which size of screw
you remove from each hole. Then, gently pull the
Right Front Shield away from the frame.
Next, loosen the M6 x 20mm Hex Screw (78). Tighten
the M10 x 50mm Hex Screw (84) until the Drive Belt
(34) is tight. Then, tighten the M6 x 20mm Hex Screw.
Finally, reattach the front shields, the shield cover, and
the right pedal.
26
34
78
84