GE DPGT750EC/GC Technical Service Manual page 28

5. Remove the 2 Phillips head screws that hold
the blower guard in place. Remove the blower
guard.
6. Remove the 13 mm center nut. (Turn
clockwise to remove.) Remove the blower
wheel.
7. Remove the 3 Phillips head screws from the
center of the blower housing. Remove the
front screw from the dryer base.
8. Remove the remaining 2 Phillips head screws
from the dryer base and exhaust duct.
Note: The motor shaft has a snap ring, which
prevents the blower wheel from rubbing the back
of the blower housing.
Snap Ring
9. Remove the blower housing.
10. With a flat blade screwdriver compress the
open end of the spring strap (one strap on
each end of the drive motor) until it releases.
11. Remove the spring straps. Remove the drive
motor from the motor bracket.
Note: The motor bracket is notched, be sure to
align the motor correctly in the bracket when
installing.
– 28 –
Top View
Spring Strap