Table of Contents
Advertisement
18. Attach the washer control board to the new
backsplash by replacing the four screws
removed from the washer control board
earlier.
19. Connect the washer control board to the new
backsplash by sliding the ribbon connector on
the new backsplash onto the metal pins on the
control board and pushing in. Make sure the
ribbon is not twisted before inserting the
connector.
20. Secure the new washer backsplash to the
rear cover using the 2 screws removed
earlier.
Screws
21. Place the gray wire from the serial port under
the strain relief of the new backsplash.
Strain Relief
22. Insert the tabs on the bottom front of the new
backsplash into the slots on the washer and
rotate the backsplash into place.
23. Secure the new backsplash to the washer
using the 2 screws removed earlier.
Screw
Screw
Rear of Washer
24. Reconnect house utilities.
25. Plug the washer and dryer back in.
Page 63
- Quick Links:
- Top Cover
- Drive Belt
- Troubleshooting
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Related Manuals for GE DPGT750EC/GC
Related Products for GE DPGT750EC/GC
- GE Profile DPGT750
- GE Profile Harmony DPGT750GCPL
- GE Profile Harmony DPGT750ECPL
- GE DPGT750ECPL - Profile Harmony 7.3 cu. Ft. Electric Dryer
- GE DPGT750ECWW - Harmony 27" Electric Dryer
- GE DPGT750GCWW - Profile HarmonyTM 7.3 cu. Ft. Gas Dryer
- GE DPGT750GCPL - Profile Harmony 7.3 cu. Ft. Capacity King-Size Gas Dryer
- GE Profile DPGT650EH