Table of Contents
Advertisement
Problem
When you press the
p
button,
appears in the display.
"
" appears on the display.
"‰
Error messages with
"
If an error message with
"
button. This cancels the error message. You may then have to
Error message
"‹‚‚
Replacing the bulb in the oven ceiling light
If the bulb in the oven light fails, it must be replaced. Heat-
resistant, 40 watt spare bulbs can be obtained from our after-
sales service or a specialist retailer. Only use these bulbs.
ã=
Risk of electric shock!
Switch off the circuit breaker in the fuse box.
Place a tea towel in the oven when it is cold to prevent
1.
damage.
Unscrew the glass cover by turning it anti-clockwise.
2.
Replace the bulb with one of the same type.
3.
Screw the glass cover back in.
4.
Remove the tea towel and switch on the circuit breaker.
5.
Replacing the bulb in the left-hand oven light
If the bulb in the oven light fails, it must be replaced. Heat-
resistant, 25 watt spare bulbs can be obtained from our after-
sales service or a specialist retailer. Only use these bulbs.
ã=
Risk of electric shock!
Switch off the circuit breaker in the fuse box.
18
Possible cause
The ceiling and side parts in the
Ÿ©
cooking compartment are not self-
cleaning. The cleaning system
cannot be run.
Automatic switch-off has been
activated. The oven stops heating.
is shown in the display, press the
Possible cause
A button has been pressed for too
long.
Note/remedy
You can only set the cleaning system if you have
retrofitted the self-cleaning ceiling and side parts
and activated the cleaning system in the basic set-
tings. See the Cleaning system section and the
Basic settings section.
Press any button.
reset the time. If the error is shown again, call the after-sales
service.
0
You can take remedial action yourself if the following error
message is displayed.
Note/remedy
Press all buttons individually. Check that the but-
tons are clean. If the error message remains,
please contact the after-sales service.
Place a tea towel in the oven when it is cold to prevent
1.
damage.
Remove the glass cover. To do this, open the glass cover
2.
from the bottom with your hand (Fig. A). If the glass cover is
difficult to remove, use a spoon as an aid.
$
Unscrew the bulb and replace it with one of the same type
3.
(Fig. B). When fitting the new bulb, make sure that it is
screwed in straight.
Refit the glass cover. Make sure that the curvature in the
4.
glass is on the right. Insert the glass at the top and push it in
firmly at the bottom (Fig. C). The glass cover will click into
place.
&
Remove the tea towel and switch on the circuit breaker.
5.
Glass cover
You must replace a damaged glass cover. Suitable glass
covers may be obtained from the after-sales service. Please
specify the E number and FD number of your appliance.
%
Advertisement
Table of Contents
