Attach The Screen Arms To The Screen - K2 Mounts K2 Series Manual

Attach the Screen Arms to the Screen

1. Unplug all cables from your screen, and then lay the screen screen-down on a flat, soft
surface, such as a table covered with a blanket. Make sure that the surface is not abrasive,
so you do not damage the screen or bezel. Make sure that you fully support the screen, but
hang any pedestal-style stand over the edge.
2. Remove the existing stand from the back of the screen so that the mounting holes are
exposed. Refer to your screen's User Guide for more information.
Warning:
!
If you do not position the Screen Arms correctly, you could damage your screen. The
top edges of both arms must be the same distance from the screen top.
3. Line up the Screen Arms as shown. The Security
Screw on each bracket should be near the bottom
of the screen, facing the outer edge of the screen.
4. Make sure that the same hole on both Screen Arms,
so that the top of each bracket is the same distance
from the top edge of the screen. The brackets
should be roughly centered top-to-bottom.
5. If the back of your screen does not lie flush with
the screen arms, place washers between the arms
and screen back to fill the gap. Do not use so many
washers as to make the bracket unstable.
6. Using the Phillips screwdriver, attach the Screen Arms to the screen. If the screws do not
feel secure in the screen mounting holes, try using the screws that originally came with the
screen. You must securely fasten the Screen Arms to the screen.
www.k2mounts.com 9