Fuse Ratings - Bosch MIC400 PTZ Installation And Operation Manual

MIC400 Series Camera | Installation and Operation Manual
Table C - Composite cable to Power Supply HD-3 Connection Table
Composite Function
Cable Wire
Colour
Red AC supply
Green AC supply rtn.
White Rx +
Yellow Rx -
Drain Wire Gnd
Blue Tx -
Violet Tx +
Coax Core Video
Coax Screen Video Return
Black Tamper Switch
(Optional)
Orange Wash drive
(Optional)
Table D –Telemetry Connections to HD3, HD4 and HD5
Telemetry HD3
Signal Name
RXB or Rx + Pin 3
RXA or Rx - Pin 4
GND Pin 5
TXA or Tx - Pin 6
TXB or Tx + Pin 7
Bosch Security Systems
Terminal Box Terminal
Connector box ID
marking
HD3-1 Power
HD3-2 Power
HD3-3 RxB
HD3-4 RxA
HD3-5 GND
HD3-6 TxA
HD3-7 TxB
HD3-8 Video
HD3-9 Vid 0v
HD3-10 Tamp Sw
HD3-11 Wash
HD4 HD5
Pin 1 Pin 1
Pin 2 Pin 2
Pin 3 Pin 3
Pin 4 Pin 4
Pin 5 Pin 5
Issue 1
Table E –Auxiliary connections (IR Lamps, PA Speakers and Heaters) to HD6
Composite Function
cable Wire
colour
Brown Heater* or IR Lamps**
or PA speakers***
Grey Heater* or IR Lamps**
or PA speakers***
*See page 19 for details on commissioning MIC400 cameras with the heater option
fitted.
**IR power supplies only, see MIC-IR Power Supplies on page for more details.
*** See page 19 for details on connecting the PA speakers.
CAUTION: Connecting MIC400IR or MIC400PA units to
a MIC-PSU with the heater option enabled as this can
result in damage to the cameras. Please ensure that the
heater link is disabled if a MIC400PA is to be used or
ensure a MIC-IR-PSU is used with a MIC400IR camera
unit.

Fuse ratings

The power supply houses 4 off 20mm fuses in fuse holders. The ratings for these
fuses if fixed on the low voltage secondary side but changes with input voltage on
the high voltage primary side.
The following table shows the fuse values fitted for the different supplies for
operating the power supply:
Note FS 4 does not exist
AAAEN | 16
Terminal Box Connector
HD6-1
HD6-2