Start Up, Enrolling And Testing The Nx-7002; Inserting The Sim Card - GE NetworX NX-7002 Installation Manual

S
TART UP

Inserting the SIM card

Note: You must be free of all static electricity when handling electronic components.
•
•
•
•
•
•
•
•
NX-7002 Installation manual
,
ENROLLING AND TESTING THE
Always power down the system before inserting a SIM Card.
Locate the SIM card holder
Open the SIM card holder by sliding the metal clip as shown in
The SIM card holder opens
Slide the SIM card into the holder using the guides. Make sure the contacts (gold pads)
face the circuit board and the angled corners face out
Ensure the SIM card is inserted correctly in the holder and close the SIM card holder
Slide the metal clip back to the original position as shown in
Power up the system. Do not enter programming mode until the SIM card selects the
network operator. The SIM card automatically selects a network operator when enrolled
on the network. To manually select an operator, enter the relevant network operator in
location 170. See Appendix 2: Operator ID Codes for a list of operator ID codes. Most SIM
cards contain a pre-programmed SMS service centre address and under normal
circumstances, this should not be changed. If you do need to change it, include the
international country prefix using a '+' instead of leading zeros. Program '13' to insert '+'
in the address.
Page 10
on the board.
.
NX-7002
and lifting the holder.
.
.
.
09/02/05