14
en | Initial Preparations
3
Initial Preparations
1.
2.
3.
3.1
Installation Guidelines
–
–
–
F.01U.240.878 | 1.0 | 2011.07
Determine the operating voltage at the installation site.
The camera's Voltage Regulator Board accepts 12-24 VDC/
VAC input without change to internal connections
Determine the optimum mounting location for the camera.
See Section 4 Camera Mounting, page 15.
All cameras have been tested and pre-focused with
telephoto setting as factory default prior to shipment. If
any adjustment needed, it is advisable to check the
camera's operation before installation.
Refer to Section 4 Camera Mounting, page 15, for
installation instructions.
It is important that these steps are followed in numerical
order.
This installation must be made by a qualified service
person and must conform to all local codes.
Instruction Manual
EX14 Marine Camera
Bosch Security Systems, Inc.