Table of Contents
Advertisement
• Check the playback frequencies of the connected speakers before
adjusting.
• While adjusting the X-over, you should consider the frequency
response of the connected speakers.
• About the 2.2ch (3WAY)/4.2ch (FRONT/REAR/SUBW.) system
You can switch to 2.2ch (3WAY)/4.2ch (FRONT/REAR/SUBW.)
system mode with the 2.2ch (3WAY)/4.2ch (FRONT/REAR/SUBW.)
switch on the PXA-H100. For details, refer to the Owner's Manual of
PXA-H100.
Adjusting the Time Correction
Before performing the following procedures, refer to "About Time
Correction" (page 48).
1
Touch [
] of T.CORR.
The T.CORR adjustment screen appears.
2.2ch (3WAY) System
FRONT L(Mid-L) / FRONT R(Mid-R) / REAR L(High-L) / REAR
R(High-R) / SUBW. L / SUBW. R
4.2ch (FRONT/REAR/SUBW.) System
FRONT L / FRONT R / REAR L / REAR R / SUBW. L / SUBW. R
2
Touch [ ] or [ ] of the desired speaker to adjust
the distance.
L = (distance to farthest speaker) – (distance to other
speakers)
Refer to "Time Correction Value List" on page 48.
3
Repeat steps 1 and 2 to set another speaker.
By setting these values to make its sound reach the
listening position at the same time as the sound of other
speakers.
Setting the Time Correction Unit (TCR
Parameter)
You can change the unit, (cm or inch) of time correction.
Setting item: T.CORR PARAMETER
Setting contents: CM / INCH
CM:
Time correction value is in cm.
INCH: Time correction value is in inches.
Graphic Equalizer Adjustments
The 7 Band graphic equalizer is adjustable.
Setting item : G-EQ
1
Select L+R by touching [ ] of G-EQ.
L+R:
Sets the same adjustment values for the left and right
channels.
When parametric EQ is adjusted, this setting will be turned
OFF.
46
-EN
2
Touch [
] of G-EQ.
The G-EQ list screen appears.
3
Adjust the G-EQ to your preference.
Selecting the Band
Setting contents: BAND 1 to 7
Touch [ ] or [ ] of BAND.
Select the desired band.
Adjusting the Level
Setting contents: -6 dB to +6 dB
Touch [ ] or [ ] of the desired frequency to adjust the
level.
• When graphic EQ is adjusted, the adjustment for parametric EQ
becomes ineffective.
Parametric Equalizer Adjustments
The frequency bands of the graphic equalizer are fixed. This makes it
very difficult to correct for undesired peaks and dips at specific
frequencies. The parametric equalizer's center frequency can be tuned
to these specific frequencies. Then, the bandwidth (Q) and level are
fine-tuned, independently, to make the necessary corrections. The
parametric equalizer function is an advanced tool for serious
audiophiles.
Setting item : P-EQ
1
Select L+R by touching [ ] of P-EQ.
L+R:
Sets the same adjustment values for the left and right
channels.
When graphic EQ is adjusted, this setting will be turned
OFF.
2
Touch [
] of P-EQ.
The P-EQ list screen appears.
3
Adjust the P-EQ to your preference.
Selecting the Band
Setting contents: BAND 1 to 5
Touch [ ] or [ ] of BAND.
Select the desired band.
Advertisement
Table of Contents
