Advertisement
Enabling Mitel SIP Phone Provisioning
This section describes how to install the Mitel configuration files so that Mitel phones can be
automatically detected and provisioned by the UC server.
Obtaining Firmware Upgrades
The UC server supports Mitel firmware version R7.1.0.7.01.00.09. ADTRAN does not distribute Mitel
firmware. If you need to obtain this firmware version, please contact your Mitel reseller.
Installing the Configuration Files
Included with this technical note is a folder containing configuration files and templates used by the UC
server to automatically detect and provision Mitel SIP phones. You must copy this folder to the UC server
folder tree (along with the Mitel firmware files as shown above in
To install the configuration files:
1. Extract the Mitel (Generic) folder from the .zip file (located in the same directory as this
document) and copy it to the PhoneTypes folder located here:
X:\Program Files\ADTRAN\NetVanta UC Server\Data\System\PhoneTypes, where X is the
drive where the UC server program files are installed.
For example, the path after the folder is copied might appear as follows:
C:\Program Files\ADTRAN\NetVanta UC Server\Data\System\PhoneTypes\Mitel (Generic)
2. Copy the Mitel firmware files (as shown above in
folder located here:
X:\Program Files\ ADTRAN\NetVanta UC Server\Data\TFTP, where X is the drive where the
UC server program files are installed.
3. Restart the NetVanta UC Server Application Service.
Select Start > Control Panel > Administrative Tools > Services.
Scroll down and select NetVanta UC Server Application Services.
Right-click the entry and select Restart.
Obtaining Firmware
Obtaining Firmware
2
Upgrades).
Upgrades) to the TFTP
Advertisement
