Installing Or Swapping A Hard Disk Drive In A Standard Scsi Disk Drive Bay - NEC Express5800 120Ld User Manual

Installing or Swapping a Hard Disk Drive in a Standard SCSI
Disk Drive Bay
This procedure describes installing a new hard disk drive or swapping out a
faulty drive from the SCSI disk drive bay. The drive bay must be removed
from the system when installing or removing a hard disk drive. Disk drives
must use the industry standard 68-pin Wide SCSI interface connector.
Note:
representative or dealer.
If installing new drives, follow an installation scheme starting with the
!
left-most drive. Fill the bays right-to-left (1 through 4). See Figure 4-19.
Figure 4-19. SCSI Disk Drive Installation Scheme
The suggested hard disk SCSI address assignment is:
!
Bay
1
2
3
4
To order a hard disk drive, contact your sales
0 1 2 3 4
4 3 2
Device
First Hard Disk (Right)
Second Hard Disk
Third Hard Disk
Fourth Hard Disk (Left)
5
1
SCSI ID Address
0
1
2
3
Upgrading Your System 4-23