NEC Express5800 120Lh User Manual page 241

10.
Connect the SCSI and power cables to the 5.25-inch device installed from the left side of
the server.
See "Cable connection" for details.
IMPORTANT:
cause a malfunction to occur. Provide the connection securely
watching the 5.25-inch device and cable connectors.
NOTE:
To SCSI connector
on mother board
11.
Install the removed components.
IMPORTANT:
as shown in the figure below.
12.
Provide the setup for the server referring to "SCSI BIOS" in Chapter 4.
Removal
Remove the 5.25-inch device in the reverse procedure of the installation.
Connector pin bending or incomplete connection may
Make sure that the cable is not caught.
Not used
To device installed in
slot 1 of 5.25-inch
device bay
Run the SCSI cable and CD-ROM drive ribbon cable
Upgrading Your Server 9-29
To device installed in
slot 2 of 5.25-inch
device bay
To device installed in
slot 3 of 5.25-inch
device bay
Termination
connector