NEC Versa 2700 User Manual page 50

If you do not have a port enabled, LapLink prompts you
to enable one. (The IR port is disabled for wireless
communications when the system ships.) Before follow-
ing the on-screen instructions to configure the IR port in
LapLink, proceed to device manager in Windows 95 to
enable the IR port.
NOTE
that the wireless (serial, com2) is currently unavail-
able, use the Device Manager under the Windows
95 Control Panel to enable the IR port. If LapLink
still fails to recognize the IR port, reboot your sys-
tem, go into Setup, and enable the port.
For information about enabling and disabling
devices, see "Enabling and Disabling Devices" in
Chapter 4.
2. Once your ports are configured, select your communica-
tion method by pressing the appropriate button. The
buttons give you the following connection options.
T
Connect over cable
T
Connect over wireless
T
Connect over modem (if installed)
T
Connect over network
T
Connect over dial-up network
Once communication is established between systems, the
LapLink window appears.
Select the procedure you want to use by pressing one of
3.
the last three buttons in the LapLink toolbar at the top of
the screen.
2-8 Understanding the Software
When LapLink displays a message indicating