Adjusting The Dtmf Code Transmit Speed - Kenwood TH-K40A Instruction Manual

• You can move the cursor to the left or right by pressing [VFO] or [MR].
• Press [CALL] to delete the character at the current cursor position.
• On the transceiver display, DTMF code " " is represented by "E" and "#" is
represented by "F".
• When a space is entered, it becomes a "Pause" code.
5 Press [F] to select the DTMF code and move the cursor to the next digit.
6 Repeat steps 4 and 5 to enter up to 16 digits.
7 To complete the entry, press [F] without selecting a DTMF code.
8 Press [MENU] or [PTT] to exit Menu mode.
TRANSMITTING A STORED DTMF CODE
1 While pressing and holding [PTT], press [MONI].
2 Release [MONI] (continue pressing [PTT]), then rotate the ENC control to
select the desired DTMF memory channel number (d0 ~ dF).
3 While still holding [PTT], press [MONI] again to transmit the selected DTMF
tones.
• The code stored in the channel scrolls across the display, accompanied by DTMF
tones from the speaker.
• After transmitting, the frequency display is restored.
• If you do not need to confirm the memory channel contents, press [STEP] (0) ~
[PF] (9), [F] (A) ~ [CALL] (D), [LAMP] ( ) (E), and [ENT] (#) (F) instead of turning
the ENC control in step 2, to select a channel number. The stored DTMF code will
be immediately transmitted. (You do not need to press [MONI] in step 3.)
Note: If you select an empty DTMF memory channel and press [MONI], the frequency
display is restored.

ADJUSTING THE DTMF CODE TRANSMIT SPEED

Some repeaters may not respond correctly if a DTMF code is transmitted at fast
speed. If this happens, change the DTMF code transmit speed; the default is
100 ms.
1 Enter Menu mode and access Menu No. 29 (DT.SPD), then press [F].
2 Rotate the ENC control to select 50/ 100/ 150 ms, then press [F] to store the
setting.
3 Press [MENU] or [PTT] to exit Menu mode.
41