Installing The Battery Pack; Installing The Belt Clip - Kenwood TH-K40A Instruction Manual

Note: Because the battery pack is provided uncharged, you must charge the battery pack
before using it with the transceiver. To charge the battery pack, refer to "CHARGING THE
BATTERY PACK " {page 3}.
1 To install the battery pack, align the base of the
battery pack with the transceiver, then press
the battery pack into place until the lock lever is
secure.
2 To remove the battery pack, push the lock lever
up, then pull the battery pack away from the
transceiver.
If desired, you can install the supplied belt clip to the transceiver.
1 Remove the battery pack, as described above.
2 To install the belt clip, align the guides of the
belt clip with the grooves on the rear of the
battery pack, then slide the belt clip into place
until the lock lever is secure.
3 To remove the belt clip, push the lock lever
towards the transceiver while sliding the belt
clip up.
2

INSTALLING THE BATTERY PACK

INSTALLING THE BELT CLIP

Lock lever
Lock lever
Belt clip
Lock lever