Base Station Installation; Dc Power Connections - Vertex Standard VX-1700 Operating Manual

I
NSTALLATION

DC Power Connections

For base station installations, Yaesu recommends the use
of the Model FP-1030A AC Power Supply. The FP-
1030A provides a regulated 13.8 V DC supply at up to 25
Ampere.
Other models of DC power supplies may be used with the
VX-1700, but the 13.8 V DC input voltage, 25 Ampere
current capability, and DC cable polarity guidelines de-
scribed previously must be strictly followed.
If you are connecting the FP-1030A with the VX-1700
for the first time, before connecting power check the
label in the rear of the FP-1030A which indicates the
VX-1700
Page 10
B S I
ASE TATION NSTALLATION
ply voltage is applied to this transceiver. Your warranty
does not cover damage caused by application of AC, re-
versed polarity DC, or DC outside of the specified range
of 13.8 V ±15%. If using a power supply other than the
FP-1030A, ensure that the DC supply connector to the
transceiver matches the VX-1700 wiring configuration.
Other manufacturers may utilize power supplies with a
physically matched connector that is wired differently; this
will cause serious damage to the VX-1700 transceiver!
Supplied DC Cable
AC mains voltage for which the supply is currently
set.
Permanent damage can result if improper sup-
0 5 10 15 20 0
V
CONTINUOUS CURRENT
POWER
ON
OFF
FUSE: 25A
VX-1700 O
FP-1030A
5 20 30 40
A O VE R LO A D
25A
RED BLACK
M