Assembly - Healthrider H55t Treadmill User Manual

ASSEMBLY

• To hire a service technician to assemble this
product in your home, call 1-800-445-2480.
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you finish all assembly steps.
• After shipping, there may be an oily substance
on the exterior of the treadmill. This is normal. If
there is an oily substance on the treadmill, wipe
it off with a soft cloth and a mild, non-abrasive
cleaner.
1. Make sure that the power cord is unplugged.
Attach a Wheel (81) to the Base (80) with a 3/8" x
2 1/2" Bolt (2) and a 3/8" Nut (3). Do not over-
tighten the Nut; the Wheel must turn freely.
Attach the other Wheel (not shown) to the
other side of the Base (80) in the same way.
2. Remove the ties securing the Upright Wire (70)
to the Base (80). Pull the Upright Wire and the
base ground wire (A) through the indicated hole
in the Base (80).
Attach the base ground wire (A) to the Base (80)
with a #8 x 1/2" Ground Screw (1).
Press a Base Cap (77) into each side of the Base
(80). Make sure that the Grommet (67) is pressed
into the square hole in the Base.
• To identify small parts, see page 6.
• Assembly requires the following tools:
the included hex key
one adjustable wrench
one Phillips screwdriver
scissors
needlenose pliers
To avoid damaging parts, do not use power tools.
1
80
2
Hole
77
A
1
70
7
2
81
3
67
80