Healthrider 275p Treadmill User Manual page 7

HOW TO FOLD AND MOVE THE TREADMILL
HOW TO FOLD THE TREADMILL FOR STORAGE
Before folding the treadmill, adjust the incline to the
lowest position. If this is not done, the treadmill may be
permanently damaged. Next, unplug the power cord.
CAUTION: You must be able to safely lift 20 kg (45 lbs.) in
order to raise, lower, or move the treadmill.
1. Hold the treadmill with your hands in the locations shown at
the right. CAUTION: To decrease the possibility of in-
jury, bend your legs and keep your back straight. As
you raise the treadmill, make sure to lift with your legs
rather than your back. Raise the treadmill about halfway
to the vertical position.
2. Move your right hand to the position shown and hold the
treadmill firmly. Using your left hand, pull the latch knob to
the left and hold it. Raise the treadmill until the latch pin is
aligned with the hole in the catch. Insert the latch pin into
the catch. Make sure that the latch pin is fully inserted
into the catch.
To protect the floor or carpet from damage, place a
mat under the treadmill. Keep the treadmill out of
direct sunlight. Do not leave the treadmill in the stor-
age position in temperatures above 30°C (85°F).
HOW TO MOVE THE TREADMILL
Before moving the treadmill, convert the treadmill to the stor-
age position as described above. Make sure that the latch
pin is fully inserted into the catch.
1. Hold the handrails as shown and place one foot against a
wheel.
2. Tilt the treadmill back until it rolls freely on the wheels.
Carefully move the treadmill to the desired location. Never
move the treadmill without tipping it back. To reduce
the risk of injury, use extreme caution whilst moving
the treadmill. Do not attempt to move the treadmill over
an uneven surface.
3. Place one foot on the base, and carefully lower the tread-
mill until it is resting in the storage position.
HOW TO LOWER THE TREADMILL FOR USE
1. See drawing 2 above. Hold the treadmill with your right hand as shown. Using your left hand, pull the latch
knob to the left and hold it. Pivot the treadmill down until the frame is past the pin. Slowly release the latch knob.
2. See drawing 1. Hold the treadmill firmly with both hands, and lower the treadmill to the floor. Do not drop the
treadmill frame to the floor. CAUTION: To decrease the possibility of injury, bend your legs and keep
your back straight.
1
2
Open
Closed
Knob
Pin
Catch
Base
Wheels
22
4. Insert a Handrail Extension (85) into the post on the left
Upright (82). If necessary, tap the Handrail Extension
with a rubber mallet to fully insert it. Align the holes in the
Handrail Extension with the holes in the post. Next, at-
tach the Handrail Extension by tightening three Short
Screws (76) into the indicated holes. Note that the hole in
the left side of the post is not used. Note: If there is only
one hole in the top of the post, tighten the third Short
Screw into the hole in the left side of the post.
Identify the Left Handgrip (122), which has a large cutout
in the right side. Slide the Left Handgrip as far as possi-
ble onto the Handrail Extension (85). It may be helpful to
apply soapy water to the Handrail Extension.
5. Make sure that the front edge of the Left Handgrip (122)
is under the Console Base (87) as shown. Tighten a
Short Screw (76) into the side of the Left Handgrip as
shown.
Attach the other Handrail Extension (not shown) and the
Right Handgrip (not shown) as described in step 4 and
this step.
Note: When assembly is completed, there may be
extra screws left over.
6. See drawing 6a. Locate the left Rear Foot (59) on the
treadmill. If the left Rear Foot touches the floor, go to
step 7. If there is a space between the left Rear Foot and
the floor, follow the instructions below.
Hold the treadmill firmly with both hands, and raise the
treadmill to the storage position as described on page 22.
See drawing 6b. Using a phillips screwdriver, remove the
Rear Foot Screw (60), the right Rear Foot (59), and the
Rear Foot Spacer (120) from the treadmill. Reattach the
right Rear Foot without the Rear Foot Spacer. Hold the
treadmill with both hands, and lower the treadmill as
described on page 22.
Carefully lower the treadmill. If there is still a space be-
tween the left Rear Foot (not shown) and the floor, raise
the treadmill and remove the left Rear Foot. Snap the
Rear Foot Spacer (120) onto the left Rear Foot and reat-
tach the left Rear Foot and the Rear Foot Spacer. Then,
carefully lower the treadmill.
7. Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen
wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 24). To protect the
floor or carpet from damage, place a mat under the treadmill.
4
Post
76
85
76
122
82
76
Cutout
5
87
76
122
76
6a
59
6b
60
59
120
7