Table Of Contents; Important Precautions - Healthrider 275p Treadmill User Manual

TABLE OF CONTENTS

IMPORTANT PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
BEFORE YOU BEGIN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
ASSEMBLY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
HOW TO USE THE CHEST PULSE SENSOR . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8
OPERATION AND ADJUSTMENT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9
HOW TO FOLD AND MOVE THE TREADMILL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .22
TROUBLE-SHOOTING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .23
CONDITIONING GUIDELINES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .26
PART LIST . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .27
ORDERING REPLACEMENT PARTS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Back Cover
Note: An EXPLODED DRAWING is attached in the centre of this manual.

IMPORTANT PRECAUTIONS

WARNING:
To reduce the risk of burns, fire, electric shock, or injury to persons, read the
following important precautions and information before operating the treadmill.
1. It is the responsibility of the owner to ensure
that all users of this treadmill are adequately
informed of all warnings and precautions.
2. Use the treadmill only as described in this
manual.
3. Place the treadmill on a level surface, with at
least 2.5 m (8 ft.) of clearance behind it and
0.5 m (2 ft.) on each side. Do not place the
treadmill on any surface that blocks air open-
ings. To protect the floor or carpet from dam-
age, place a mat under the treadmill.
4. When choosing a location for the treadmill,
make sure that the location and position
permit access to an electrical plug.
5. Keep the treadmill indoors, away from mois-
ture and dust. Do not put the treadmill in a
garage or covered patio, or near water.
6. Do not operate the treadmill where aerosol
products are used or where oxygen is being
administered.
7. Keep children under the age of 12 and pets
away from the treadmill at all times.
8. The treadmill should not be used by persons
weighing more than 113 kg (250 lbs.).
9. Never allow more than one person on the
treadmill at a time.
10. Wear appropriate exercise clothes when using
the treadmill. Do not wear loose clothes that
could become caught in the treadmill. Athletic
support clothes are recommended for both
men and women. Always wear athletic shoes.
Never use the treadmill with bare feet, wearing
only stockings, or in sandals.
11. When connecting the power cord (see page 9),
plug the power cord into an earthed circuit.
When replacing the fuse, on ASTA approved
BS1362 type should be fitted to the fuse car-
rier. A 13 amp fuse should be used. No other
appliance should be on the same circuit.
2
PART LIST-Model No. HETL40730
To locate the parts listed below, see the EXPLODED DRAWING attached in the centre of this manual.
No. Qty. Description No. Qty.
1 1 Motor Belt 47 15
2 1 Pulley/Flywheel/Fan 48 1
3 4 Motor Nut 49 2
4* 1 Motor/Pulley/ 50 1
Flywheel/Fan 51 1
5 1 Incline Motor Bolt 52 1
6 1 Plastic Incline Motor 53 4
Spacer 54 4
7 1 Incline Motor 55 1
8 1 Stop Bracket 56 1
9 1 Small Nut 57 1
10 3 Star Washer 58 1
11 4 Thick Base Pad 59 2
12 1 Frame 60 4
13 1 Latch Assembly 61 1
14 1 Splitter 62 5
15 8 Incline Motor Nut 63 1
16 4 Hood Screw 64 1
17 4 Plastic Stand-off 65 2
18 1 Hood Bracket (short) 66 1
19 1 Hood Bracket (long) 67 1
20 2 Warning Decal 68 4
21 1 Reed Switch 69 6
22 1 Reed Switch Clip 70 1
23 1 Motor/Controller Wire 71 1
24 1 Controller 72 5
25 1 Electronics Bracket 73 1
26 1 Circuit Breaker 74 1
27 1 Receptacle 75 2
28 1 Grounding Nut 76 14
29 1 On/Off Switch 77 1
30 1 Ground Wire 78 1
31 1 Incline Leg 79 4
32 2 Frame Pivot Bolt 80 1
33 2 Frame Pivot Spacer 81 4
34 1 Upright Wire Harness 82 1
35 1 Front Roller Adj. Bolt 83 2
36 4 Roller Adj. Washer 84 1
37 2 Motor Tension Nut/ 85 2
Front Roller Nut 86 2
38 4 Motor Bolt 87 1
39 2 Cap Screw 88 1
40 1 Left Foot Rail Cap 89 10
41 2 Foot Rail 90 1
42 1 Front Roller/Pulley 91 1
43 1 Magnet 92 1
44 2 Platform Centre Screw 93 1
45 2 Isolator 94 1
46 4 Isolator Screw 95 2
Description No. Qty. Description
Plastic Fastener 96 1 Incline Motor Shield
Shield 97 2 Base Pad
Belt Guide 98 1 12" Audio Wire
Book Holder 99 2 Upright Grommet
Front Belly Pan 100 1 Allen Wrench
Power Supply 101 19 Screw
Cable Tie Clamp 102 1 Edge Trim
Cable Tie 103 2 Extension Leg
Walking Belt 104 2 Upright Endcap
20" Wire Harness 105 1 Shock
Rear Roller 106** 2 Extension Leg
Belly Pan Spacer Assembly
Rear Foot 107 2 Pulse Bar Bolt
Rear Foot Screw 108 2 Pulse Bar Washer
Ground Wire 109 1 Pulse Bar
Ground Wire Screw 110 1 Right Handgrip
Belly Pan 111 1 Audio Wire Nut
Rear Endcap 112 1 European Power Cord
Rear Roller Adj. Bolt 113 1 Rubber Ring
Motor 114 2 Interface Bracket
Latch Decal 115 1 Filter
Platform Screw 116 1 Console Base Bottom
Electronics Screw 117 2 Upright Endcap
Latch Catch 118 1 Chest Pulse Sensor
Walking Platform 119 21 Hood Bracket Screw/
8" Cable Tie Incline Shield Screw
Jack 120 1 Rear Foot Spacer
Motor Tension Bolt 121 1 Chest Pulse Strap
Foot Rail Insert 122 1 Left Handgrip
Short Screw 123 2 Static Decal
Console 124 1 Hand Pulse Wire
Choke 125 1 Choke Bracket
Long Screw # 1 8" White Wire, 2F
10' iFIT.com Wire # 1 14" White Wire, 2F
Motor Bushing # 1 8" Blue Wire, 2F
Upright # 1 4" Blue Wire, 2F
Incline Leg Pivot Bolt # 1 4" Black Wire, M/F
Motor Mount Isolator # 1 4" Black Wire, 2F
Handrail Extension # 1 4" Green Wire, F/Ring
Wheel Bolt # 1 8" Green Wire, F/Ring
Console Base # 1 8" Green Wire, 2 Ring
Motor Tension Washer # 1 14" Blue Wire, 2F
Console/Latch Screw # 1 4" White Wire, M/F
Key/Clip # 1 4" Red Wire, M/F
Incline Motor Plate # 1 User's Manual
Right Foot Rail Cap
Motor Tension Bushing * Includes all parts in the box
Motor Hood # These parts are not illustrated
Front Wheel
27
R0603A