Healthrider 250p Treadmill User Manual page 9

INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR
If you purchase the optional chest pulse sensor (see page 20), follow the steps below to install the receiver and
the short jumper wire included with the chest pulse sensor.
1. Make sure that the power cord is unplugged. Remove
the indicated Screws (46) from the Console Back (116).
Remove the Console Back from the Console Base (87).
2. Connect the short jumper wire (A) to the wire on the re-
ceiver (B). Connect the other end of the short jumper wire
to the PULSE jack on the back of the Console (87) (see
drawing 2b). (Note: If there is already a wire plugged into
the PULSE jack, unplug it.) Next, peel the paper off the
adhesive pad on the back of the receiver (B). Turn the re-
ceiver so the cylinder is in the position shown, and at-
tach the receiver inside of the Console Base (87) in the in-
dicated location. Use the included plastic tie to tie wires if
needed. Note: The other wires included with the receiver
may be discarded.
Make sure that no wires are pinched. See step 1.
Reattach the Console Back (116) with the Screws (46).
1
2a
A
Cylinder
B
9
116 87
46
2b
87
PULSE
Jack
87