Epic Fitness A35e Elliptical Manual page 8

3. Set the Rear Stabilizer (5) on the floor behind
the Frame (1). Locate the wire tie in the Rear
Stabilizer.
See the inset drawing. Tie the end of the wire
tie to the Sensor Wire Harness (155).
Pull the other end of the wire tie until the Sensor
Wire Harness (155) is routed through the Rear
Stabilizer (5).
4. Tip: Avoid pinching the Sensor Wire
Harness (155).
Set a sturdy piece of packing material under the
rear of the Frame (1). Have a second person
hold the Frame to prevent it from tipping
while you complete this step.
Insert the Rear Stabilizer (5) into the Frame (1).
Attach the Rear Stabilizer with four M8 x 16mm
Screws (72); start all four Screws, and then
tighten them.
Remove the packing material.
5. Untie and discard the wire tie (not shown) on the
Sensor Wire Harness (155).
While a second person holds the Rear Stabilizer
Cover (2) near the Rear Stabilizer (5), connect
the wire on the Ultrasonic Sensor (147) to the
Sensor Wire Harness (155). Insert the excess
wire into the Rear Stabilizer.
Tip: Avoid pinching the Sensor Wire Harness
(155). Press the four Mounts (117) on the under-
side of the Rear Stabilizer Cover (2) into the
Rear Stabilizer (5).
3
Wire
5
Tie
4
Avoid pinching
the Sensor Wire
Harness (155)
5
155
5
Avoid pinching
the Sensor Wire
Harness (155)
2
117
147
155
5
8
1
155
155
Wire
Tie
Wire Tie
72
72
1