How To Adjust The Reed Switch - Epic Fitness A35e Elliptical Manual

HOW TO ADJUST THE REED SWITCH

If the console does not display correct feedback, the
reed switch should be adjusted.
Press the power switch to the off position and
unplug the power cord.
To adjust the reed switch,  rst see assembly step 11
on page 11. Remove the Left Roller Arm (12) from
the Left Pedal Arm (44).
Next, see EXPLODED DRAWING A on page 41 and
EXPLODED DRAWING B on page 42. Remove the
M8 x 16mm Screw (72), the Axle Cover (53), and the
M8 x 25mm Washer (149) from the upper end of the
Left Roller Arm (12). Then, remove the Left Roller Arm
from the left Crank Arm (20). Set the Left Roller Arm
out of the way.
See EXPLODED DRAWING C on page 43. Using a
 at screwdriver, pry the left Crank Arm Cover (71) off
the Left Front Shield (73).
Next, locate the Reed Switch (38). Turn the left Crank
Arm (20) until one of the Magnets (43) on the Pulley
(19) is aligned with the Reed Switch.
43
38
104
19
20
36
Loosen, but do not remove, the two M4 x 16mm
Screws (104). Slide the Reed Switch (38) slightly
closer to or away from the Magnet (43). Then, retighten
the Screws. Plug in the power cord and press the
power switch to the reset position. Turn the left Crank
Arm (20) for a moment.
Repeat these actions until the console displays correct
feedback. Then, reattach the left crank arm cover and
the left roller arm.
STORAGE
If the elliptical will not be used for an extended period
of time, lay the power cord over the elliptical where it
will not be pinched or crushed, and cover the elliptical
to keep it free of dust. Store the elliptical indoors. Do
not store objects on the elliptical.