Assembling The Power Pro; Locate The Rear Leg And Seat Rail - Bowflex Power Pro Assembly Manual

Assembly manual

Hide thumbs Also See for Power Pro:

Owner's manual (80 pages)

Table Of Contents

Table of Contents

Step 1:

Locate the Rear Leg and Seat Rail.

1a.

Take two 3/8" x 3/4" square head bolts and place them

through holes on the Rear Leg Bolt Keeper. Take that

assembly and slide it into the Seat Rail channel, starting

on the end closest to the warning label. Make sure to

line up the end of the bolt keeper with the end of the

rail. Repeat for the other bolt keeper.

Once you have both bolt keepers in place, install the

Rear Leg – place four 3/8" washers and tighten a 3/8"

nylon locknut on to each of the bolts.

Please use caution when inserting the bolt keeper.

Edges may be sharp.

1b.

Next, take two 3/8" x 3/4" square head bolts and slide

one into each side of the Seat Rail channel from the

opposite end. Locate the Riser Bracket and attach it to

the Seat Rail with the two square head bolts. Wait to

tighten bolts with a wrench until after Step 1c.

1c.

Now, locate the bolt keeper for the pivot bracket and

two 3/8" x 3/4" square head bolts. Install the bolts into

the bolt keeper. Slide them into the Seat Rail Channel

making sure the keeper is flush with the end of the Seat

Rail. Repeat for the other bolt keeper.

Locate the Pivot Bracket and Pulley Frame. Snap

Bracket between the screw heads on the Pulley Frame.

Install the rail so the four bolts at the front of the rail

slide through the four holes in the pivot bracket.

Use 3/8" washers and 3/8" nylon lock nuts to

secure the rail.

IMPORTANT: Place Seat Rail so that

the end of the rail is flush with the edge

of the Pivot Bracket.

Connect the bottom of the Riser Bracket

to the standing platform with the 1" Knob.

See example 1c.

NOTE: You may need to pull up on

the standing platform, near the hole,

in order to get the screw to thread

into the hole.

IMPORTANT: Make sure the Pivot Bracket is between the two screws

under the main frame before tightening Seat Rail to Pivot Bracket.