Assigning A Channel Number - Sennheiser Tourguide UHF Instructions For Use Manual

28
Note:
If the transmission frequencies of two simultaneously operated
transmitters are too close to each other (spacing < 400 Hz), this
may cause interference. We recommend using the factory-preset
frequencies (presets).
Before you program new frequency combinations, please refer to
the information on the correct frequency choice given in the
planning brochure "Practical Applications in RF Technology" which
your local Sennheiser agent has in stock or will be pleased to order
for you from Sennheiser.
Select the frequency memory for which you wish to set a
frequency
Select the "tunE" menu by pressing the
appears on the display; after a short pause the currently set
frequency is displayed.
With the / buttons you can now select a different frequency.
The frequencies are tunable in 25-kHz steps. The new frequency
starts flashing on the display and becomes effective
immediately.
Press the SET button to return to the top menu level. The display
then switches back to the standard display.

Assigning a channel number

You now have to assign the frequency memory a channel number
(from 0 to 255). With larger systems, we recommend using the
same channel numbers for both transmitters and receivers in order
to provide for simpler monitoring of the system.
Select the frequency memory for which you wish to assign a
channel number.
Select the "CH no" menu by pressing the
"CH no" appears on the display; after a short pause the currently
assigned channel number is displayed.
With the buttons you can now select a different channel
/
number. The new channel number starts flashing on the display
and becomes effective immediately.
Note
Channel numbers which have already been assigned to a fixed
frequency memory are skipped.
SET
Press the button to return to the top menu level. The display
then switches back to the standard display.
SET button until "tunE"
SET button until