Wall-Mounting The Charger; Charging The Accupack/Receiver - Sennheiser Tourguide UHF Instructions For Use Manual

Wall-mounting the charger

The charger is already prepared for wall mounting, the
corresponding openings
The mounting material is not included in the delivery.

Charging the accupack/receiver

The BA 1035 accupacks can be charged either attached to the
receiver or separately. For charging the accupack, insert the
EK 1035 receiver with an attached accupack or an individual
accupack into a charging compartment of the L 1035 charger.
Note:
The receiver's on/off switch is automatically set to "OFF" when
the receiver is inserted into the L 1035 charger.
The charging process is automatic. Since the accupacks cannot be
overcharged, the accupack or the receiver with the accupack can
remain in the charger even when the charging time has been
exceeded.
After an initial charging time of 16 hours, the accupacks offer an
operating time of approx. six hours.
The charging process restarts after a power failure or after the
accupack has been removed from the charging compartment and
inserted again. However, the accupacks cannot be overcharged.
Indicator LEDs
Green LED:
Red LED:
are at the rear of the charger.
The accupack in this charging compartment
is fully charged.
The accupack is being charged.
13