Computer Associates ARB6002700WF0. ..... - BRIGHTSTOR ARCSERVE 2000 Manual page 35

To configure network communication, follow these steps:
1. Open the Backup Agent Admin.
2. From the Options menu, select Network Configuration:
3. Using this dialog, set the following network parameters for the client
agent:
Specify Port Number—Accept the defaults or enter the port values you
want BrightStor ARCserve Backup to use. If you want to use the
original default port, click the Reset button. The updated port
information will be saved in the local PortsConfig.cfg file located in
\Program Files\CA\SharedComponents\BrightStor.
Note: Updated port information must be registered with the BrightStor
ARCserve Backup server component. To do this, you must modify the
remote server PortsConfig.cfg file. For more information on port
configuration, see the Administrator Guide.
Enable VI (virtual interface) support—Enables the VI protocol for
backup and restore.
Select IP Address—The Windows client agent supports the use of
multiple network interface cards (NICs). For computers with more than
one network card, the agent checks all enabled NICs in the machine.
You can manually override this selection by choosing the IP address of
the NIC that you want to dedicate for backup purposes. When you
define this configuration, the client agent will listen using only this
interface card. All other NICs are ignored and you will not be able to
use their IP addresses to connect to the client agent.
Windows Client Agents Configuration
Adding and Configuring the Client Agents 35