File Management - Gateway SZSL95IN0XXXXXXXX Reference Manual

You cannot see the other computers on your network
•
•
•
•
•
•
•
Your Ethernet network is running slower than you expect
•

File management

Help and Support. Type the keyword/phrase System Restore in the Search
Help box, then press E
A file was accidentally deleted
If a file was deleted while holding down the S
cannot be restored, because it was not sent to the Recycle Bin.
80
CHAPTER 5: Troubleshooting
Make sure that your Ethernet cable is plugged into your
computer's power module. Make sure that the other end
is plugged into a network router, switch, hub, or other
network device.
Make sure that all computers are plugged into a
powered electrical outlet and turned on.
Make sure that the router (if you are using one) is
plugged into a powered electrical outlet and turned on.
Most routers have lights that indicate they are working.
For more information, see the documentation that came
with your router.
If you are using a router, try restarting it by unplugging
its power cord, waiting five seconds, then plugging it
back in.
Make sure that all computers on your network have the
same workgroup name.
Make sure that all computers are using the same Subnet
mask.
If you assigned IP addresses to the computers, make sure
that all computers have different IP addresses. For home
networks, IP addresses should be 192.168.N.N where N
is a number you assign between 0 and 254. The first N
should be the same for all computers on your network
and the second N should be different for all computers
on your network.
If your Ethernet network is running slower than you
expect, check the speed of each Ethernet component.
For best results, all Ethernet components should be
standard Ethernet (10 Mbps), Fast Ethernet (100 Mbps or
10/100 Mbps), or Gigabit Ethernet (1000 Mbps or
10/100/1000 Mbps). A mixture of Ethernet, Fast
Ethernet, and Gigabit Ethernet components will result in
your network running at the slowest component speed.
Help
For more information about restoring deleted files, click Start, then click
.
NTER
key, the file
HIFT