Changing The System Battery - Gateway SZSL95IN0XXXXXXXX Reference Manual

4
5
6

Changing the system battery

same or equivalent type recommended by the manufacturer. Dispose of used
batteries following the manufacturer's instructions.
If the computer clock does not keep time or the settings in the
BIOS Setup utility are not saved when you turn off your
computer, replace the system battery. Use a battery of the
same size and voltage as the original battery that was in your
computer.
To replace the battery:
1
2
56
CHAPTER 3: Upgrading Your Computer
Lift the end of the graphics card or spacer to about a 30°
angle, then slide it out of the card slot.
Slide the new graphics card into the card slot at a 30°
angle, then secure it to the computer using the two
screws you removed previously.
Close the back panel by following the instructions in
"Opening and closing the case" on page
reconnect all cables.
Warning
Danger of explosion if battery is incorrectly replaced. Replace only with the
Restart your computer.
During the restart, press and hold the F2 key. The main
menu of the BIOS Setup utility opens.
46, then