Gateway MAN FX510 Reference Manual page 61

www.gateway.com
4
Remove the hard drive by sliding it out of the drive bay.
5
Note any jumper settings on the old drive and set the
jumper on the new drive to be the same. If you are
installing a new drive, follow the manufacturer's
instructions.
6
Slide the new drive into the drive bay, then secure it in
the drive bay by sliding the drive release latch in toward
the computer.
7
If you are replacing a drive, reconnect the drive cables
using your notes from
drive, follow the manufacturer's instructions for
connecting it to the system board.
8
Replace the side panel by following the instructions in
"Replacing the side panel" on page
9
Reconnect all external cables and the power cord.
10
Turn on your computer.
11
If you installed a new drive, format and partition the
drive according to the manufacturer's instructions
(available on the manufacturer's Web site).
Jumper
Step 3. If you are installing a new
44.
55