Gateway E-6300 User Manual page 17

Component
Cover release lever
Voltage switch
Case cover
thumbscrew
Rear speaker jack
(black) (optional)
Ethernet (network)
jack
Parallel port
PS/2 keyboard port
S-Video out jack
(optional)
Telephone jack
(optional)
Power connector
Icon Description
Lift this lever to open the computer cover.
Before turning on your computer, make sure that this switch is
in the correct position for the correct power available. The
switch is preset at the factory with the correct voltage for your
area.
In the United States, the utility power is supplied at a nominal
115 volts at 60 Hz. The power supply should always be set to
this when your computer is operating in the United States. In
other areas of the world, such as Europe, the utility power is
supplied at 230 volts at 50 Hz. If your computer is operating
in an environment such as this, the voltage switch should be
moved to 230.
Remove this screw before opening the case.
Plug your rear right and left speaker into this optional jack. For
information on configuring this jack, see
jacks" on page
Plug a 10/100 Ethernet network cable or a device (such as a
DSL or cable modem for a broadband Internet connection) into
this jack.
For more information, see "Learning about the Internet" in
Using Your Computer which has been included on your hard
drive. To access this guide, click Start, All Programs, then click
Gateway Documentation.
Plug a parallel device (such as a printer) into this port. For more
information, see
peripheral device" on page
Plug a Personal System/2
Plug a standard S-Video cable into this optional jack. Plug the
other end of the cable into an S-Video jack on a television.
Plug a telephone cable into this jack.
Plug the power cord into this connector.
www.gateway.com
28.
"Installing a printer, scanner, or other
30.
®
(PS/2) keyboard into this port.
"Configuring the audio
11