Gateway E SERIES E-6000 User Manual page 105

4
If you are replacing a drive, slide the old drive forward and out of the drive
bay.
- OR -
If you are adding a new drive, slide the drive bay cover forward and out
of the drive bay.
5
Set any jumpers on the new drive. If you are replacing a drive, match the
jumper settings on the old drive. See the drive documentation for further
instructions.
6
Slide the new drive into the drive bay until it settles into the indentation
and is flush with the front of the computer case, then slide the release lever
toward the front of the case.
7
If you removed a shipping screw, replace the screw.
8
Reconnect the drive cables using your notes from Step . The red-striped
edge of the data ribbon cable indicates Pin 1 and corresponds with Pin 1
on the drive (typically on the side farthest from the power supply
connection). For more information, see the drive documentation.
9
Close the case by following the instructions in "Closing the case" on
page 95.
www.gateway.com
Adding or replacing a drive
99