Gateway E-4100 User Manual page 64

3
If you are removing a DIMM from the memory module bank, gently pull the plastic
tabs away from the sides of the memory module and remove it.
- OR -
If you are adding a DIMM to an empty memory module bank, gently pull the plastic
tabs away from the sides of the memory module bank.
4
Align the notches on the new DIMM with the notches on the memory module bank
and press the module firmly into the bank. The tabs on the sides of the memory
module should secure the memory module automatically. When the module is secure,
you hear a click.
5
Close the case by following the instructions in
6
Reconnect the cables and the power cord.
7
Turn on your computer. Windows starts and the Windows desktop appears.
8
Click
Start
Click/Double-click
bottom of the System Properties dialog box in the General tab.
58
, , then click
Control Panel
. The amount of memory in your computer is shown at the
System
"Closing the case" on page
Performance and Maintenance
www.gateway.com
56.
(if in Category view).